| Measurement of Sonobuoy Transmitting Antenna System for Anti-Submarine Warfare |
|
Kyeong-Sik Min |
|
Dept. of Radio Science & Engineering, Korea Maritime University |
|
|
|
|
| Abstract |
|
This paper describes the measured results of sonobuoy transmitting antenna system for anti-submarine warfare (ASW). Since radiation pattern and power density depend on impedance matching between transmitting RF part and antenna with termination resistance, design of matching circuit is very important for sonobuoy system performance. Matching circuit is designed by Smith chart using control of L and C. In standing wave ratio(SWR) measurement using Network Analyzer, SWR of antenna with matching circuit observed 1.5 below at the assigned VHF band. It shows very excellent performance comparison with conversional product that is used for the same object. The measured vertical and horizontal radiation patterns are also shown the satisfaction of military specifications. A drop out of sonobuoy system on the sea is happened when angle of elevation direction is over 10 degrees, and it is conformed that it takes less than I second return to original signal level. The required electric power density is $83;mW/m^2$ in the military specification, and measured electric power density is observed over average $110;mW/m^2$ at all frequency bands. |
| Key words:
Sonobuoy, Radiation Pattern, Drop Out, Power Density, Spurious Radiation |
|
PDF Links
Full text via DOI
Download Citation
